Flame - Large

Açıklama

7/1/2026Flame - LargeThis is my first attempt at making a flame. The purpose was to make a "fireball" for the dragon prop. However, this prop can also be turned 90 deg and look like a flame!It is made for typical 12mm bullet pixels. I recommend 4" spacing to avoid splices. I did measure and the farthest distance shouldn't be more than 3.5".It is composed of 48 separate pieces. (there are 2 test pieces used to test print and don't attach to the flame).Most pieces are 6mm thick with a 2mm thick raised edge that is 10mm high. I believe this will be plenty strong and use less material than my previous attemptusing 10mm thickness through out.Its approximate size is 836mm wide x 1259mm high (33.5in x 50.3in).It holds 191 bullet pixels. (yes, I know not quite 200!)Printer:All the parts should be able to be printed on a minimum bed size of 220x220mm. Assembly:Please use the two Assembly pictures to see how to put it together. The picture with "Assembly" in the name shows how the pieces fit together. Mounting:As for mounting, I did place mounting holes to mount this to a basic rectangular framework.If you are looking for mounting hardware you can find it here: https://www.thingiverse.com/thing:7263329Thank you for looking at or even attempting to print this. I would be interested in any feedback. I'll correct any mistakes as quickly as possible. Learning from previous props, I did add plenty of bracing for the model. I hope it doesn't distract from the overall appearance of the…