Surveillance Camera Base

Açıklama

This is a 5.25" diameter (135mm) camera base I designed that will accommodate most residential bullet and dome surveillance cameras. The base is about 2" high (50mm) when the top and bottom are joined - I needed this for my residential security system to not only mount the camera to the underside of the eves/overhangs of my home more easily, but to drop the camera down a few inches so the view was not obstructed by the angled overhang.Here are the details for the files:Cam Base Ported: This is the base with a port in the side for an ethernet cable. Note, you will need to run the cable through the port before crimping the RJ45 head. I used rubber grommets from Amazon to make the port sealed against moisture. The size will depend on the diameter of your ethernet cable, which is why I purchased the 100 piece assortment of sizes. There is also a half inch hole in the base of the mount that will accommodate a 1/2" drywall anchor, which is what I use to mount these to stucco surfaces.Cam Base No Port: Identical to above with no ethernet cable port.Cam Base Top: This is the top portion of the base and is designed for M4 screws.Seal: You can use TPU filament and print this seal if you're concerned about water/particles penetrating the mount.Let me know if you have any questions or good ideas for improvement.