Revomaze Mapper Ver. 2

Açıklama

Warning:Using a mapper will defeat most of the challenge Revomaze puzzles have to offer. Only use a mapper once you've pulled out most of your hair, and are suffering from recurring Revomaze nightmares.The first version of the Revomaze mapper flipped the orientation of the core maze horizontally and vertically, making it difficult to understand and solve certain dynamic puzzle elements. This version correctly matches the position and orientation of the core maze by moving the map from the sleeve to the core, and the pen from the core to the sleve.I used M4X20 and M4X40 socket head cap screws, 2 washers, and 2 nylon lock nuts for assembly.Assembly:Print the test piece and check the fit of your pen in the hole before printing the larger pieces. Make any necessary changes to the model and print all the the pieces.Insert one bolt, washer, and lock nut in the map holder and leave the screw loose. Do the same for the pen holder holder.Cut a strip of paper 45 mm wide and place it on the map holder. Tape the paper in place while holding the paper tightly to the map holder. Make sure your pen will write on the tape you choose. Use a sharp knife to remove the ends of the paper on the inside of the map holder.Place the map holder on the side of the puzzle with the dot marker, aligning the gap with the serial number on the puzzle's core. Tighten the bolt with enough pressure to keep the map holder in place, but not so tight that it breaks the plastic. This is a 3D printed part after…