Ring for Flex Radio FlexControl

Ring for Flex Radio FlexControl

Ücretsiz STL Moda ve Takı
  • 24 görüntülenme

Bu model Thingiverse üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Thingiverse üzerinde görüntüle ↗

Açıklama

This is a replacement ring for the FlexControl USB VFO knob for the FlexRadio 6000/8000/Aurora series radios.It is installed in place of the two factory O-rings. It needs to be printed out of TPU so it will stretch over the aluminum knob. Remove the knob from the FlexControl to make installation much easier/safer. It is removed with a 1.5mm hex grub screw. The replacement ring has a hole you should line up with the grub screw so it is easy to tighten the knob back on after the ring is installed.

Bu model hakkında

Ring for Flex Radio FlexControl, Thingiverse topluluğunda paylaşılan ücretsiz bir Moda ve Takı 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Thingiverse üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller