Tormek DBS-22 angle setting Jigs and tray

Açıklama

Several years ago I made a fixed offset (13 degrees) secondary angle setting jig/gauge/guide for the Tormek DBS-22. It added 13 degrees to the 7, 9, 11, and 14 degrees of the primary drill bit facet setting jig/gauge/guide to make drill bit sharpening on the Tormek more consistent and faster. https://www.thingiverse.com/thing:7356762After some discussion with the guy (R.C.) behind the Sharpening Handbook web page (https://www.sharpeninghandbook.info/index.html), I decided to make a individual jigs for each primary angle that is listed in the twist drill section of that web page. 5 to 15 degrees. I again added +13 degrees to that primary facet angle to give the secondary facet angle and also added +22 degrees (to secondary) for anyone that wants to cut a tertiary facet.You can print them individually for your needs or print the whole set to have more sharpening options in the future. USE: Just like the original Tormek setting jig, you place this against the grinding stone and then move the DBS-22 to be flat on the bottom for that specific angle. The angle (degrees) value should be at the junction of the grinding stone and the DBS-22 flat. For Primary and 2ndary angles you'll read the jig from the left side of the Tormek. And for the tertiary angle, you'll have to flip it and read from right2026-7-9 Edit: I made a simple tray to hold the set of guides. This fits all of them.