ExoGuitar - Head - Classical

Açıklama

Part of the ExoGuitar project — full catalog, build planner, and assembly guides at https://exoguitar.comPlan Your Build & Get HardwareExoGuitar can be confusing! Head over to our build planner to plan your entire build - it'll walk you through every available part and handle compatibility along the way, and it covers all ExoGuitar parts. It's also the best way to get hardware, since it lets you buy everything for a full build in one go, not just this part.You can find this specific part, ExoGuitar - Head - Classical, on our site.After printing, make sure you clean out ALL support material. The smallest amount in the gearboxes can cause interference, the tollerances are very tight.Step 1: Put in Heat Set InsertsStep 2: Put in BearingsStep 3: Assemble 6 TensionersStep 3a: Cut TPU Filament StubsCut 6x 5mm long pieces of TPU filament. A model for a jig to cut these to size easily is included hereStep 3b: Assemble ShaftNote that the TPU filament piece is inserted BEFORE the heat set insert is installed.Step 3e: Prep Worm gearUsing a 3/32 drill bit, remove 3mm of material from one side of the worm gear hole. Then install the heat set insert into that hole. BE CAREFUL and make sure you go in straight and that you don't melt the gear teeth.Step 3f: Assemble KnobThe screw should go right up to the end of the worm gear but not stick out of it.Use locktite or super glue to lock the screw into the gear. I recommend Locktite RedStep 3r: Install TensionersStep 3f: Lubricate gears…