Toroid Winder

Açıklama

Coil Winder - Fixed & Complete RemixThe original model from 2019 was great, but the creator unfortunately uploaded it with a crucial missing part and hasn't fixed. Since I actually needed to use this thing, I had to fix it myself. Luckily, the original creator included a single combined mesh file of the whole assembly. I dragged that mesh into Fusion and isolated the missing part, then added it among the other files. The tolerance error should be around 0.005mm or so IDK, which is practically non-existent for 3D printing anyway. Note: This is a Remix post. The core mechanical design belongs to the original creator; andersontyler174 I just fixed the missing parts and did the assembly work to make it actually printable and usable for everyone.What Is This Thing? (From the Original Creator)According to the original author, this thing is a low-cost solution to wind toroids easily (especially if you need like 100+ windings and don't want your hands to bleed). It's specifically sized for rings with an OD of 1.592", ID of 1.180", and 0.5" height. The bobbin can be popped out so you can wrap it and put it back. He also mentioned making a hand crank back in 2019 but he never uploaded it, so you either use the motor setup or spin it yourself IDK.Required Hardware & Non-Printed Parts: The Motor: He used a 28BYJ-48 stepper motor. He notes that it is very slow and mostly for demonstration, but it works. Screws & Nuts: You'll need 5x of 0-80 screws and nuts to hold the main…