RC AJ1-A SkyFalcon EDF Jet

Açıklama

It's Official!! My first ever RC Aircraft modeled. I modeled this about a month ago but I did some minor tweaks before posting it here. There were a ton of challenges when it came to designing an EDF Jet like thrust line, intake flow, EDF fitting, servo location, etc. Good news is that it has enlarged trapezoidal wings and should have enough pitch authority to fly decently. Also, the intakes are large enough for air to pass through the EDF efficiently and it has a cheater grill for the middle cover.Here are the electronics you need. For tailerons, you might need to physically add control horns but I'll add them later on if I have time this week. Also, you might need to mirror the wings, elevators, and tailerons and print them as the right side because the files are for the left side. Baseline Electronics:2X SG90 or MG90 ServosZeee 3S 2200mAh BatteryIAB-6 Recieveri6X TransmitterFor a 45mm EDF (SCALE DOWN BY 96.5% FOR ALL PARTS)AEO RC 45mm EDF30A or 40A ESC For a 50mm EDF (SCALE UP BY 108% FOR ALL PARTS)Any 50mm EDF WITHOUT SIDE TABS50A ESCFor a 64mm EDF (SCALE UP BY 135% FOR ALL PARTS)Any 64mm EDF WITHOUT SIDE TABS60-70A ESCSlicer Settings (PLA or PLA +):2 Walls 5% Gyroid for the Nose and Front Section1 Wall 4% Gyroid for the Middle and Back Section 2 Walls 8% Gyroid for Wings, Elevators, and TaileronsGLIDE TESTING: I haven't printed the RC Variant yet but I have made the glider version and when I tuned the CG to be nose heavy, I glide tested this jet 30-45 times and it does…