RC PT1 Camaro

RC PT1 Camaro

Ücretsiz STL Araçlar
  • 23 görüntülenme

Bu model Thingiverse üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Thingiverse üzerinde görüntüle ↗

Açıklama

An RC Warbird Trainer that I made from scratch without any EDF issues whatsoever.Electronics List:2212 1400KV Motor7X3.5 or 7X4 Prop30-40A ESC3S 11.1V 2200mAh2X SG90 or MG90 ServosFlysky IAB6 RecieverFlysky I6X TransmitterUnlike the SkyFalcon, this plane should be more stable as it's actually based off of the P51 Mustang, has a thick wing root, has washout to prevent nasty tip stalls, 2-3 degrees of dihedral to help roll stability, and a decent tail moment arm. I made this plane a month ago but made it bigger to accommodate electronics better. I am confident this can fly but it has all moving stabs in the rear so you might need to lower rates and increase expo (50-60% rates and 35-50% Expo) due to propwash. CG is marked by my two holes. Didn't calculate it but because it's a straight wing aircraft, CG is 25% of the distance from the leading edge. I suggest to make it conservatively nose heavy before flying so that it remains stable. Hope you enjoy.Length: 456mmWingspan: 564mm

Bu model hakkında

RC PT1 Camaro, Thingiverse topluluğunda paylaşılan ücretsiz bir Araçlar 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Thingiverse üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller