Olight Odin Protector

Açıklama

This design is compatible with the Olight Odin series. I have tested the fitment and use this design on: Odin, Odin S and Odin GL. The protector does not affect the spotlight of the Odin nor the laser on the Odin GL. However, the light spill is reduced and has a honeycomb pattern. I have based the design off my successful sight kill flash as not only are they BB resistant but a popular design (https://cults3d.com/en/3d-model/game/lpvo-kill-flash-scope-protector & https://cults3d.com/en/3d-model/game/1x22-kill-flash-scope-protector). I have not been able to test the print to the same standards however it has held up to 5 shots point blank in the same location at 1.2j with 0.4g BBs before failure. The design has a 3mm air gap to the front glass with vent holes around the exterior to prevent thermal build-up and damage to both the torches and the print. The protector is a tight friction fit, allowing for the protector to be swapped when damaged while not falling off during use. For use with the Odin GL, I recommend removing the warning sticker and aligning the laser with the gap in the honeycomb. When using PAHT-CF the design resists the head from the torches without deforming retaining the integrity. I tested using the Odin S at full power for >15 minutes with no warping or weakening. Disclaimer; Always wear appropriate eye protection when handling airsoft replicas. Replace the protector after being shot or after extended periods being exposed to sunlight and the elements. I…