Tuna holder

Açıklama

I have provided you with the Tunze holder for the Nanostream pumps. I have tested it on my 6065, but it should also fit all Tunze pumps of the same design... as the pump was too wobbly for me in the original holder, I have made this design a little tighter so that the pump cannot be twisted by snails etc. The holder is completely decoupled from the magnet and therefore from the glass. the holder is completely decoupled from the magnet and thus from the glass. original magnets and vibration dampers (blue) were also tested. due to the uv light of the lamp, I printed the holder from ASA, with 6 wall lines and 30% infill) I printed it upright, and only support structure under the 4 drill holes, these can be easily removed.