SQUARE BRICK CHIMNEY MULTIPLE SCALES

Açıklama

This SQUARE BRICK CHIMNEY is intended to be printed multiple times so you can stack the layers for your desired height. The initial size is for 1:12 dollhouse scale, but can be reduced to 50% in XYZ for 1:24 scale, and even down to 1:48 scale "O" gauge for model railroads. Two chimney tops are included. I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two pieces of scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on styrene and PLA for years. No sloppy or messy glue to show when finished. I have always painted my models with oil paint, specifically Windsor and Newton Griffin Fast Drying Oils. They dry overnight. I never liked acrylics because they obliterate fine detail, and they always look chalky to me. Oil colors are made from the finest color pigments available; color saturation and permanence are proven throughout the history of art. Thinned with Mineral Spirits you will get the most remarkable weathering and aging finishes you have ever seen. I feel reasonably assured that once you try Griffin Oils you will never go back to water based acrylics. Easy cleanup with Mineral Spirits. Here's an interesting point for me to bring to your attention. Every model that I have designed is based on real world measurements and therefore each…