Botgrinder Demibot Drone Frame Goodies

Açıklama

1) xt60 front mount 2) DJI 03 mount plate antenna, backpack combo mount 3) Demibot Super Pawws carbon protection. Pawws I print in PETG at about 50+ percent with 3-line walls. These are a super tight fit, but will snap into place. If you feel like it is too tight, you can use a heat gun to loosen up the PETG and fit it nicely to the arm. 12mm screws will be required to mount the motors. -XT60 mount and 03 mounts. I print in TPU at 20-50% 3-line walls supports will be needed for the backpack. Backpack does support SMA connections for the 03, as well as LHCP SMA antennas Link to UFL to SMA - https://amzn.to/457pYZ0 Link to screws - https://amzn.to/4786mXh Link to antennas - https://amzn.to/4obBOKr