SpringBee - c47 3d

Açıklama

Small Bee with a springy bodyOptional models for a multicolor print---If you want to sell prints of this model write to me, I can prepare a commercial licensed version---Printing tipsPrinted with 0.16 and 0.2 layer height2-3 wallsNo supports neededSome infill may be usefull (7-10%)Arachne wall generator NOT recommended (use Classic instead) - it makes some ugly lines on top in few placesMay be harder to print than typical modelsYou will need a good bed adhesion and a good coolingYou may be needed to separate spring coils from each other after a print. Usually just with your finger nails, in some more rare cases with a thin knife (scalpel)It mostly depends on your seam settings and filament stringingMULTICOLORSelect SpringBee and all of MULTI files, then drop them in slicer, merge together and select color for each partMulticolor files are with a 'frame' that helps with models aligningDO NOT try to 'repair' the models - frame will not be printed and it's not causing any problems with slicingTips if the model is breakingFilament should be dry and with good self adhesionPrinting with wet filament will make the model more brittle (especially PLA) and model may break when stretchedSilk filaments (especially dual or tripple color) and the ones with particles (like 'marble') may not be a good option - but it all depends on the filamentYou can try printing it slower, bonds between layers should be stronger---