Bread Packet Clip & Hanging Bracket

Bread Packet Clip & Hanging Bracket

Ücretsiz STL Düzenleyici ve Saklama
  • 16 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

A clip and bracket set to keep bread - and anything else you choose that lives in plastic packets - sealed and fresher for longer. The bracket will let you hang your packets rather than have them taking up space on a counter. There are two versions of the clip - the rectangular version can be used independently, however it is designed with the bracket in mind while the circular variation is designed to be used as a stand alone piece if you prefer not to use the bracket. The bracket needs two screws (3 - 4mm diameter), it mounts horizontally, ideally at the base of a cupboard where the bread can hang freely. The bracket should be mounted with the slit on the back nearest the lowest part of the bracket - the slit angles downwards slightly to reduce the chance of the clip slipping out.

Bu model hakkında

Bread Packet Clip & Hanging Bracket, Cults3D topluluğunda paylaşılan ücretsiz bir Düzenleyici ve Saklama 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller