Suppository mold

Suppository mold

Ücretsiz STL Diğer
  • 10 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

This is a mold that allows to create suppositories using cocoa butter, coconut oil or other mediums. It allows to create four 9x35 mm suppositories. To make one, just duplicate the model (the halves are symmetrical). For best quality, clean the print and sand the connecting surfaces flat with fine sandpaper, that will prevent possible leaks. Using instructions: 1. Put the mold together using either two 4mm screws with nuts (recommended!) or rubber bands. 2. Freeze it (to further prevent leaks and get your suppositories faster) 3. Pour the melted butter/oil using a syringe. 4. Store vertically in a fridge for 2-3 hours. Enjoy! ;>

Bu model hakkında

Suppository mold, Cults3D topluluğunda paylaşılan ücretsiz bir Diğer 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller