Robotic hand - Mos

Açıklama

You will need four SG90 motors. Print three arms, Print 3 axis, Print 3 Left support, Print 3 right support, Print 3 fingers. Print 3 Pacifier shaped supportsAssembly;put the axis in the hole of the finger, and attach the axis into the left support, and the right. (this will now be called fingerPack) Repeat three times.Insert the SG90 motor into the hole of the single cylinder. (This will be the hand)super glue the Finger pack to the hand. Repeat three timesPlug in the worm screw into the SG90 motor which is located in the hand.Insert the SG90 motors into the hole of the three arms.Super glue the Pacifier shaped supports onto the flat surface of the hand, and the three arms.Connect the Pacifier shaped support onto the SG90 on each of the three arms.