The Happy Rooster by Donya Quick

Açıklama

A cheerful rooster in the style of my earlier hen model, The Happy Chicken (should have called that one "Happy Hen" but didn't know I'd make another chicken at the time!). This rooster model stands on its own but I still recommend a base for smaller models to avoid tipping if on uneven surfaces. The small round base from The Happy Chicken is what I used in the photos. Printing at 32mm tall will put this model to scale with a 25.4mm tall happy hen. This model has solid and hollowed verions. The solid version should be used for most smaller models (32mm or under). There is a supported chitubox file for a 32mm solid rooster. The hollow version maintains the center of gravity so the model balances well but will be lower strain on the FEP for larger resin prints, but it still has reasonably thick walls for a sturdy feel to the final result at a larger scale such as 64mm. The nature of the supports required will vary with scale; place them abundantly along the center line of the underside, and give attention to other areas depending on the print angle: underside of tail feather arches, underside of back of comb, and back side of lower legs. I like to place a few extra lighter supports along the underside of the wings too to help stabilize the model. The final hollow model will need some time to drain fully in a standing position before final curing, otherwise the drain holes may clog/seal leaving some liquid inside. Painting ideas: roosters often have a larger variety of colors on…