Collimator jig

Collimator jig

Ücretsiz STL Aletler
  • 12 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

Two jigs to help you collimate your collimator. One for 1.25" collimators and the other for 2" ones or to use it with a coma corrector attached. Use clamps or screw it on a table and another clamp to tighten the upper part to secure your collimator. Project the laser dot at a distant wall, tape a paper and mark the laser dot position in different angles. Center the dot using the collimator's collimation screws so as the dot remains in the center on every angle.

Bu model hakkında

Collimator jig, Cults3D topluluğunda paylaşılan ücretsiz bir Aletler 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller