Hoof Shoe

Açıklama

Cloven hoof: https://cults3d.com/en/3d-model/fashion/cloven-hoof-shoe Heel add on: https://cults3d.com/en/3d-model/fashion/detachable-heel-for-hoof-shoes Hoof Shoe that can be scaled to fit your feet. Made these for my feet, 10" (25.4cm) from back of heel to tip of toe while standing. I included a printable skeleton that can be used to verify the size before printing the full thing. Printing scale = Your foot length/10"(25.4cm) example: if your foot measures 8.5" from back of heel to toe tip then 8.5/10 = 0.85 or print at scale 85% Then print the skeleton to verify Two models each with and without supports. One with and one without a sew strip on top. You can use leather and cord to tie them to your feet or I found gluing a cheap flat/flexible sole works good too If using the glue in shoe: I found the cheaper flat soled shoes work better because the epoxy bonds to the cheaper out soles better than higher grade shoe VERY IMPORTANT YOU HAVE TO BE WEARING AND STANDING IN THE HOOF SHOES WHILE THE EPOXY CURES, I had to throw out a failed attempt because I clamped them in and they ended up not being in far enough. So make sure your comfortable and be prepared for a wait. Just spread glue on the contact area of the shoe (picture above) and stand in them for the curing time. It says 30mins but I did an hour in case the tube was older (old tubes take longer to cure) I needed for glue in shoe: -"https://www.amazon.ca/Weld-50139-Plastic-Adhesive-Syringe/dp/B01IBOK7FE" get two packages…