A12 Setup Station

Ücretsiz STL Diğer

12 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Açıklama

This is a setup station and holder specifically designed for an Awsomatix A12. It may work with other 12th scale cars but was not designed for them. I have used this station to set my car up, it is likely not as accurate as a purchased station but does get better consistency in camber than the stock holes on the car. Angles on the camberguage part are taken from the straight edge of the protractor. I do plan a revision to both the camberguage and steering bar after some feedback. Files will be provided to anyone who downloads. You will need two M3 screws to attach the camberguage to the camber jig. UPDATE I have updated the steering bar with a new design. This ruler should be better at toe-in and toe-out measurement. The image shown is on my GT12 car which is a CRC CK25. I have a version of this setup station for the CK25 that I will be posting soon.

Bu model hakkında

A12 Setup Station, Cults3D topluluğunda paylaşılan ücretsiz bir Diğer 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.