IPi V2i by FFFTechnology

Açıklama

No silly commercial this time ;) So this is a direct iteration of the original IPi V2 (https://www.myminifactory.com/object/3d-print-96079)Normally this would be considered a version 2.5, but there were so many small changes, along with a hardware change, that this is instead going to be a separate "Improved" version, so to speak. With that being said, this is the list of design changes. Exterior: The camera system is slightly thinner Many edges have been chamfered, removing several sharp corners from the camera system I/O ports slightly enlarged Taller ventilation ports Camera Base is thicker, allowing the camera system to take heavier loads from accidental cord pulls Camera base has been skeletonized, along with 1 extra wall perimeter for extra strength 2 less screws are needed to mount the camera pcb Camera view port is enlarged Camera sunshade has been lengthened Camera body assembly screw points have been relocated closer to the center. (See Note 2) Interior: Mounting pegs for the raspberry pi zero w have been swapped out for a pass through screw mount (See Note 2) Screw mount towers have a higher chamfer angle relative to its base, making it more sturdy and less prone to snap off A bracket has been built into the bottom of the camera body to hold the camera in place, replacing the 2 previous mounting screws A socket was designed above the camera view port for the SMD plug to rest against, allowing the camera pcb to sit flush against the mounting surface (SMD socket…