USB Voltage Controller Housing

Açıklama

I designed this as part of a stir plate project, which will be posted separately. The purpose is to house not only a small voltage controller component, available on Amazon (https://amzn.to/3LuSHyV) and on AliExpress, but the USB cable (male end) too. Thus, a single housing not only encases the controller, but holds the USB cable together as a single unit. When printing, I actually paused printing just before the "cap" started printing the flat surfaces that cover the board. The fit is snug, but I successfully printed 36 of these to make two classroom sets of stir plates. I've provided both this single-piece model and a simple two-piece design that would be glued together once the board has been inserted. The Tinkercad model is at: https://www.tinkercad.com/things/1bWlp1QZfY6?sharecode=GGY_GYr6nVmyt7b2tlksdXDZ0dSThyOKbBL6QV8CUxQ