ENDER 3 S1 PRO CR TOUCH NO Y OFFSET

Açıklama

Do you like my work? Can you support me (https://ko-fi.com/zuffdesign) with a ☕ or maybe a 🍺? It all depends on the moment 😄 Support plate for moving the CR Touch closer to the nozzle, while keeping the original 3010 fan. This ensures greater mesh accuracy. You can find my other design for moving the probe but replacing the fan with a 5015 or 4020 radial here (https://cults3d.com/:896429) I took my inspiration from JHenley01's model, which I completely redesigned from scratch to fit the S1 Pro perfectly, as I had a few problems with the fit of the original, which is intended for the S1. I reworked the model to fit the S1 PRO correctly. The rigidity of the part where the probe is attached and the top part (cable support attachment) have also been increased. There's a wedge to lower the CR-Touch probe if you're using a longer hotend. You can cut it in your Slicer to any length you like. CR Touch offsets are : x_offset: -46.5 y_offset: 0 Hardware for CR-touch probe: 2x M3 nuts With KLIPPER You can modify the offset in the "printer.cfg" file: [bltouch] x_offset: -46,5 y_offset: 0 You may also need to adjust your mesh if you get an error. I use the values below: [stepper_x] position_max: 254 [bed_mesh] mesh_min: 30, 30 mesh_max: 205, 205 With MARLIN To change the position of the CR-Touch probe, you can modify your firmware or use gcode commands. Download and install Pronterface and connect your printer via USB. Then, in the terminal on the right, you should be able to use the…