ENDER 3 V2 LED SUPPORT

Açıklama

English Designed for: ENDER 3 V2 (could fit other models if they share same rail and holes). The model fits on the back of the right rail, using the holes that come from the factory. Model advantage: *Does not obstruct mechanisms *Vertical illumination so that the light always illuminates the part when printing without the hotend covering the part. *Can be screwed on with 1 screw which comes extra original *Easy assembly *It has upper and lower hole for ventilation of the led. Need: Screw: 2* M4*0.7 screws L=15mm max (one comes as a spare in the printer). Led model: chip5630 "White", 3 segments of 3 leds = 150mm (width 10mm) (see picture). Led protective plate: Acrylic plate 150mm*((15mm (-0.2)) *1mm(thickness) (see picture) Electric wire: bipolar, outer section 2mm*4mm (20AWG 300v 80º) Switch: dimension 13mm20mmH=12mm Transformer: 12v 1A (VDC) tip when printing: place the model as designed, use the hole base in the direction to the bed, so that the switch hole is at the top. This is because it is better to make supports on non-usable parts, in order to preserve the tolerances of the led sockets. Note that brackets should not be placed inside where the cables travel, since it would be difficult to remove them. Anyway you are free to choose how to do it. If you, need some special modification, do not hesitate to consult me, if it is within my possibilities, I can do it. English Designed for: ENDER 3 V2 (could be used for other models if they share the same rail and holes)…