简介
Spread the load / increase fixing area when mounting insulation/plasterboard with screws. 60mm Diameter. TIP: Print without supports by moving 1mm below the build plate (z-axis -1mm). There is an additional 1mm deep notch on that side that faces to insulation, this adds even more support like most retaining clips. However, it becomes more difficult to print, so far I've never needed it. Printing at 0.2 or 0.3mm doesn't seem to affect practical usage.
About this model
Insulation Load Spreading Retaining Washer is a 免费 3D model in the 其他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
