简介
This telescope collimator is in 2 ", it is a project in court, soI do not tested and I do not printed..It is intended for LEDs of 3mm, the rear part must be glued after the LED wiring. If you want to change it leave me a message. Ce collimateur de télescope est en 2 ", c'est un projet en cour, donc je ne l'ai pas testé et je ne l'ai pas imprimé..Il est destiné a des LEDs de 3mm, la partie arrière doit être collée après le câblage LED. Si vous voulez le modifier laissez-moi un message.
About this model
collimator is a 免费 3D model in the 其他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
