Laptop Riser/Stand - UnbreakableThief

简介

Laptop Riser:I needed this to keep my laptop at the same height as my T.V. since I use my T.V. as a dual monitor. I have 2 sizes of laptops (280mm and 240mm) and it works beautifully for both. I added a strip of rubber drawer liner (Walmart has it in the kitchen department for about $5 a roll) to the top and under the feet to prevent it from slipping when my kids bump my desk, but it worked just fine without it as well. I printed at 20% infill; I doubt anymore is needed for any weight Laptop. PLA works just fine.The hole in the foot is 8mm while the peg in the arm is 7mm, slips in and out very easily. I did this to line the peg with superglue before inserting into the hole. The completed riser is 50mm tall and 175mm Long. Dimensions of Riser:*Feet: *Arm:-Bottom: 60mm -Length: 175mm-Top: 25mm -Width: 25mm-Height: 45mm -Height: 5mm