LED Upgrade Bits for Monolith by Stefan Ha
- 13 次浏览
该模型托管于 MyMiniFactory。文件、图片及许可信息归原创作者所有。
在 MyMiniFactory 查看 ↗简介
Printable Bits for upgrading a Monolith for use of LEDs. - The crystal has a hole for a 5mm LED on the bottom. I printed it in Glass PET-G with 0% Infill, 5 bottom- and top layers, and 3 walls. No support required. - The portal consists of two pieces - the holder, and the event horizon. The holder has a hole for a 5mm LED on one side, on the other side comes the portal. after fitting the LED, I'd put something for diffusing the light on it. I used translucent silicone, as seen in the picture. Again for the portal, I used Glass PET-G. this time with 100% Infill, for not creating holes inside it | Download free and paid 3D printable STL files
About this model
LED Upgrade Bits for Monolith by Stefan Ha is a 免费 3D model in the 其他 category, shared by the MyMiniFactory community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on MyMiniFactory. Use the button above to open the original page and download it.
