Filament Runout Sensor for Scalar 3D Printers
- 11 次浏览
该模型托管于 Thingiverse。文件、图片及许可信息归原创作者所有。
在 Thingiverse 查看 ↗简介
DescriptionThis plastic part is a Filament Sensor Module for Scalar 3D printer.It allows to detect the end of filament and trigger a filament change on firmware side.Updates2017.04.02 - Minor fix, the button could sometimes get stuckCompatibilityCompatible with both 1.75 and 3mm filamentThis is compatible with Marlin RC8 firmware.Just un-comment the runout sensor section on the firmware (near line 776)Stuff neededAll you need is a mechanical switch with a roller at the end such as this one:http://3dmodularsystems.com/en/electronic/74-micro-switch-end-stop-with-roller-for-3d-printers.htmlWiringOn ramps board you need to connect one end of the switch to the last servo pins (SERVO3_PIN).One wire is to be connected to the Signal pin and the other wire is to be connected to the ground pin.3D Modular SystemsEvolutive 3D Printers You enjoy it and want to help us with a donation: https://www.paypal.me/3DMShttp://www.3dmodularsystems.comTwitter: https://twitter.com/3dmodularsystemYoutube: http://www.youtube.com/c/3DModularSystems3DPrinters
About this model
Filament Runout Sensor for Scalar 3D Printers is a 免费 3D model in the 其他 category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.
