Retro USB Floppy case

Retro USB Floppy case

免费 STL 收纳整理
  • 15 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

A case for adding a real 3.5" floppy drive and USB controller board. The design language is taken from old Commodore drives. A standard PC floppy drive screws in from the bottom (I cannot guarantee that other drives will match the hole pattern. Also drives with no bottom shroud should be checked for clearance.). The USB controller is basically the same one you can find all over (example on Amazon: https://www.amazon.com/gp/product/B07WCRF9H3/ ) I put a cable tie on the cable where it exits the case for strain relief. 3mm screws are used for the case and floppy, I used countersunk screws. There are also divots in the bottom for 11.5mm rubber feet. It's only a buck!

About this model

Retro USB Floppy case is a 免费 3D model in the 收纳整理 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型