Piwars balloonholder

Piwars balloonholder

免费 STL 数码配件
  • 19 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

This is a 3D printable version of the balloon holder for the pi-noon part of the Piwars challenges (piwars.org). It is not an official Piwars holder, just one I made to allow me to practise jousting balloons :-). It has been configured for a 2mm thread that you make a length of 17 cm and another length as you see fit. (don't know the dimension for that part). The freecad design file is also present so you can adjust the design for another kind of thread. You can add a little tape at the bend part to make the clamp fit tightly. Use two 3mm bolts to clamp the thread.

About this model

Piwars balloonholder is a 免费 3D model in the 数码配件 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型