Spray Stick for Priming or Basecoating Miniatures

Spray Stick for Priming or Basecoating Miniatures

免费 STL 微缩模型
  • 23 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

This is my version for a device that allows you to apply primer/basecoats to up to 5 minis at a time using rubber bands. Assembly instructions: Just insert the Pin from the bottom of the Handle through the hole, screw on the Spacer (not too tight) and then screw the Top Part on top. I recommend using thicker rubber bands for better grip, but office rubber bands will do just fine.

About this model

Spray Stick for Priming or Basecoating Miniatures is a 免费 3D model in the 微缩模型 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型