简介
After several years of use my aluminium extractor hood filters are worn out. The little notches broke off and the lever was tired. I was shocked to see what new filters cost (brand Pelgrim). Filters are okay, only the mounting system has gone bad. I designed and printed these magnet holders and inserted 20x3mm magnet into them. The holders can be pushed inbetween the edge and the filter. Magnets are strong enhoug to hold up the filter onto the hood. 1 unlock lever was also broken. A replacement for that is also availeble. Pri open the holder carfully, remove old lever put new one in, and close holder again. (wtch out not to break the notches on the side like i did :-( ) Searching for 3D printed designs? Take a look at my Etsy store GraverEn3D.Etsy.Com
About this model
Extractor Hood Filter Fix is a 免费 3D model in the 其他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
