Wing access panel holder

Wing access panel holder

免费 STL 数码配件
  • 25 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

I know that there are multiple ways to attached the access panels on the wings. Glue them in, clear tape, and etc. I made these screw on plates to hold them on, incase I need to remove the access panel. The download is enough to support one wing so you would have to print it twice. The screws are plastic/nylon 6-32 bought at your local hardware store same as the 6-32 nuts that snap into the inside plate. I did make these for the RVJET but could be modified for any wing.

About this model

Wing access panel holder is a 免费 3D model in the 数码配件 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型