简介
The original design is good but I found that it had a few weakenesses, namely the microphone cable at 90 degree angle which would break without any strain relief. My remix now requires you to loop the wire and use a zip tie to hold the wire onto the arm, a shoulder is added for the ziptie to sit against so it doesnt slide. I have also changed the dimensions of the magnet used, it is now 7x2mm, I have added 0.25mm of tollerance in both the arm and the mount, on my test print it sat perfectly in place.
About this model
Headset boom mic is a 免费 3D model in the 其他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
