Centauri Carbon 1 Riser with plexiglass sides

简介

Updated models for taller pillars (200mm) and side panel for Canvas! (currently untested, but matches all the specs online) You will need 5mm plexiglass: 2 pieces @ 280mm x 197mm, and 2 pieces @ 285mm x 197mm. The right side will need to be cut out to accommodate the canvas panel if you go that route. Everything glues together with CA glue and silicone. Have you modified your CC1 to have a vertical USB cable? I did! My original USB cable frayed, so when I got a 2nd machine, I immediately ditched the cable chain and printed a strain relief and ran everything vertically. This 130mm riser allows for the cable and PTFE tube to clear everything, while still using the stock glass top. Bonus, you can stack it on any other vented riser that you might find online! I've doubled up so I can retain the vent options. If you have access to 5mm plexiglass, you will need 2 pieces @ 280mm x 127mm, and 2 pieces @ 285mm x 127mm. You could also print 4 of each of the panels I've included in the files, and glue them together (but it won't be transparent) The Channel pieces glue into the pillars, and the plexiglass or panels slide into the assembly. If you want, the trim pieces can go around the upper lip to keep the consistent look of the tapered top edge. Not needed, but I threw them in there just because. Stay tuned for my test files for the Canvas system! It's a more complicated system, and it will be 180mm tall (maybe taller once I can actually test with the Canvas!) Links to other CC1 files…