Modular Deckbox V2

简介

Improved version of my V1 Modular Deckbox, desing for more easy printing and almost no supports needed (just the picatinny rails need them on the sides). This V2 is also a LOT thinner than V1, so it's cheaper and still have the same modularity of my previous design. you can also print my coin separately and glue them on the box. The dice cabinet is inside the larger box, so if you want you can only print one box and two 1-side rails (with the picatinny's). It uses just 4 (5x1mm) neodymium magnets per rail, and it needs M4x10mm metric flat screws to connect the picatinny's on the box. (NOTE: The rails are not compatible with my V1 model since i had to made them a little bit more spaced so it can fit the screws properly).