Macbook adjustable power brick support

简介

Solving the main issue with Apple Macbook power bricks! Trying to solve the most frustrating thing with Apple Macbook power bricks! These things are big and heavy. When plugged into a wall outlet, there's a lot of strain on the plug and the whole thing is wobbly and dangerous. When plugged into a power strip, the weight doesn't allow the power strip to stay straight on a table. This model solves these issues by adding adjustable support feet to your Macbook brick. This is a simple and fast print, that can also be a good opportunity to use the last meters of a filament roll. Prints without supports, with 3 layer walls. Print as shown, with the screws laying on the bed. Includes two set of screws (long ones and shorter ones). Pay attention to the fact that there's a left screw and a right screw. They should fit perfectly, but turn in opposite directions; if this is not the case, swap them and/or turn in the other direction. I used Prusament jet black PETG, with a 0.4mm nozzle and 0.15 layer height. But PLA and 0.20 layer height should be perfectly fine.