简介
This is a remix on the v7 nut by boghonkI found that the v7 was not wide enough at the base to secure the underbody of a 2020 Golf R.This version has a small change of a 30mm base. This will allow you to secure the nut into the base panel of the underbody.The 10mm hex head remains. Print in whatever filament you believe suitable. I've printed temporarily in PLA with no issues.INSTALLATION - Carefully start threading the nut onto the stud by hand and then slowly thread on and back until the thread is cut into the plastic. Then secure the nut into the underbody and install as normal.
About this model
Golf 7.5 - Underbody Nut is a 免费 3D model in the 其他 category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.
