5K spool holder

5K spool holder

免费 STL 数码配件
  • 14 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

this was the original - https://www.thingiverse.com/thing:3353204 just made the wheels and railswider for bigger rolls print 4 of the rails and 4 wheels. Requires a "608" type bearings like in fidget spinners. I used 2 bearings per wheel https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions. I have created a smaller version to fit the right-front corner and the back-center. A M3-.50 nut is required.

About this model

5K spool holder is a 免费 3D model in the 数码配件 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型