简介
I needed a super simple, super quick test pattern to test the z-offset on my BLTouch so I whipped this up in FreeCAD. All it is is a 150mm square bisected horizontally and vertically with one solid circle in each corner and one solid circle in the middle. The lines are all 0.8mm wide (2 perimeters with a standard 0.4mm nozzle); the corner circles are all 8mm in diameter; and the center circle is 16mm in diameter. Cura defaults to a 0.3mm layer height for the first layer, so that is the height of this pattern. Printing at 0.2mm (essentially 0.3mm since it's only the first layer) with a print speed of 40mm.sec, this print only takes four minutes - not including the warm up time or time spent running a leveling profile.
About this model
Super Simple and Quick Test Pattern is a 免费 3D model in the 其他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
