Vacuum wall mount

Vacuum wall mount

免费 STL 数码配件
  • 22 次浏览

该模型托管于 Thingiverse。文件、图片及许可信息归原创作者所有。

在 Thingiverse 查看 ↗

简介

Vacuum cleaner mount with 2 adapter holders and charging cable slotRecommended print material: PETG or ASA. I used ASA due to its higher heat resistance where Tg_ASA ≈ 100°C (my kitchen gets a lot of direct sunlight) and its slightly higher stiffness/strength. PETG should work just as well for this application.You'll also need 2 nails/screws for mounting. The damper pads were cut from dense foam and glued on, but any TPE/TPU with a sufficiently low Shore hardness would work as well.

About this model

Vacuum wall mount is a 免费 3D model in the 数码配件 category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.

相似模型