Panda Breath filter cover for Snapmaker U1
- 29 次浏览
该模型托管于 Thingiverse。文件、图片及许可信息归原创作者所有。
在 Thingiverse 查看 ↗简介
When you install the Panda Breath in the SnapMaker U1, the bracket prevents you from sliding the lid open for the filter housing, making changing filters more difficult than necessary. I removed the filter cover, and designed a replacement that attaches with magnets to the metal body of the Panda Breath. Instructions:Remove the four screws holding the filter cover to the Panda Breath. Magnetically attach this in its place, using four 10mmx2mm magnets. I printed mine in Tinmorry PETG-GF, which should hold up to the max 65 degree chamber temperature. Though you can certainly print it out of ABS or ASA for even better heat protection. A 40 minute print that uses just 13.5g filament and no supports if you print it face down.
About this model
Panda Breath filter cover for Snapmaker U1 is a 免费 3D model in the 兴趣与DIY category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.
