Overhead Streaming Camera Tripod Setup

简介

I wanted to be able to easily record/stream when I'm doing electrical or hardware work, so I made a modified version of the work from Ingo, using a different size extrusion and webcam, and also mounted a raspberry pi for easy system running. I also plan to mount a mini monitor in the future so I can see what the camera sees.This is still a work in progress, so expect updates as I go.In total, I wanted a "complete" overhead camera system, which included the camera, a light to make things brighter and clearer, both a wide angle and macro lens so I could should close up and bigger areas, a computer to handle streaming/recording the video, and a mini monitor so I could see both what the camera sees, and any chat comments/etc if I'm using it for streaming. All attached to the single overhead extrusion! (So I could just.... move it around my apartment as I worked in various areas)I also ended up adding a microscope because... That's just a useful thing for me. The arm I found for it was nice but didn't quite work for my needs, so I ended up just remaking it from scratch, using their design as a basis.As part of this, I predominantly tried to use what I had on hand, so these are by no means the "best" options for the task. That said, all the non-3D printed parts are listed here (plus or minus some screws/nuts/wire... but the screws should all be M3s)FrameStandard tripod20mm T-slots aluminum extrusion (or any ~< 20mm square rod to mount to. This is what I had on hand)M3x8 screw…