简介
There's four or five charge cords with adapters laying around here, and losing the adapter is always a concern. So I've been wanting to make these connectors for a while.The filament is rubbery 95A TPU. The Micro adapters in the photo are actually smaller than the cords' USB-C ends, but one size stretches to fit all. And resizing these to fit whatever needs it, is entirely possible. A percent or two in length might be right. Four took 20 minutes using Orca Slicer's generic TPU filament... The only adjustment I made was adding a little 2 mm outer brim, because these have a small footprint. And even with zero gap, the brims pulled right off.
About this model
USB adapter loop is a 免费 3D model in the 其他 category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.
