简介
Light Up Snowman. This light up snowman, uses Bambu LED kit 001. or similar 6cm led puck. All parts print separately. i would advise to print all parts on the same printer. Dependent on your printers tolerances the parts maybe tight or slightly loose. I've gone for a mid range tolerance, if tight they will clip in, if a little loose you may need a dab of glue. The base with the led puck screws and clips in. 0.2 layer. 10-15% infill. There are some very small parts p[lease ensure good adhesion. im using bambu super tack plate and had no issue printing. on a texture pei plate i would suggest a little glue. Avoid a brim if possible as it will be hard to get the brim off and then the part fit in the slots. There is also a non light version i will upload shortly | Download free and paid 3D printable STL files
About this model
Light Up Snowman by ENIQUE3D is a 付费 3D model in the 其他 category, shared by the MyMiniFactory community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on MyMiniFactory. Use the button above to open the original page and download it.
