TPU flight controller softmount (universal)

TPU flight controller softmount (universal)

免费 STL 数码配件
  • 16 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

simple softmount for the drone racer´s flight controller. it only makes sense to print it if you do it in flexible material. central hole is 2mm in diameter, to allow a tight fit to the 3mm screws. original file is 6mm high. but you can rescale the z axis to any desired high in your slicer software. avoid infill so it does not get too stiff. no supports needed either. 15min printing time for four units together at 10mm/s. really light (I didn't even care to weigh them) please, share it if you print it!

About this model

TPU flight controller softmount (universal) is a 免费 3D model in the 数码配件 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型