Pot Planter - jay606

简介

Flower potter plant, Make this as high as you want, just print the center tube and 2nd tier cups. All addon cups after the firts tier are 2nd tier cups. They allow for drainage into the pots below Print directions are below.Master Information• Overture Matte White• 200 degrees• Ender 3 S Pro• Cura 5.3.1Base – 4Hr 1 Min 86g• .6mm Nozzle• 10% infill - Triangle• Lineo Width .6o Height .2• Top & Bottomo 4 Layers• Speedo Print 100o Wall 100o Initial 20• Travelo Retraction Enable .8 mm 40 mm/s Retract before outer wallCenter Pole – 7Hr 53 Min 127g• .4mm Nozzle• 10% infill Lines• Print Speed 100 mm/s• Walls 75 mm/s• Slow layers 10 @ 10 mm/sTop Planter – 1Hr 38 Min 17g (I printed 1 at a time)• .4mm Nozzle• Infill 10%• Wall Line count 4• Bottom 4 layers• Speedo 100 mm/so Outer wall 75 mm/s• Orientationo Print Top opening facing upo Tree SupportBottom Planter – 6Hr 22 Min 72g (this is all 4)• Speedo 100 mm/so Outer Wall 75 mm/sGrow Cup – 4Hr 18 Min 69g • .4mm Nozzle• Upside down on build plate widest section• Tree supports• Speedo 100 mm/so 50 mm/so Initial layer speed 10 mm/s 5 layers• 20% Infill