12V voltage regulator case (parametric)

简介

A simple case to hold a 12V voltage regulator such as the one sold on AliExpress here. The model defaults are for that specific regulator but the parameters can be modified to accommodate others.UsageCheck to make sure the regulator works the way you expect it to (i.e. you're not undervolting based on supply)Print both the box and lidStrip the wires as needed and run them through the provided holes on either side of the baseScrew the wires into the voltage regulator as requiredSlip the regulator into place, aligning the standoffs and knobCheck the fit of the lidUsing your method of choice (heated filament, soldering iron, glue, etc.) fuse the lid and the base togetherScrew the knob hex nut into placeSlide the knob dial onto the knobRecommended Print Settings0.4mm nozzle0.2mm layer height10% infillNo supportsPrint as orientedParameterspiece (text, dropdown): Print the base or the lidboxWidth (number): The width of the outside of the boxboxDepth (number): The depth of the outside of the boxboxRoundness (number): The radius of the corners and edgesboxThiccness (number): The thickness of the wallscutOutRadius (number): The radius of the knob cutoutcutOutHeight (number): How high the cutout should be from the bottom of the boxwireXOffset (number): Move the wire hole toward the front or rear of the box (will not prevent you from removing the hole entirely by accident)wireZOffset (number): Move the wire hole toward the top or bottom of the box (will not prevent you from removing…